inVoca User Guide - Page 39
Q. I have to keep repeating "louder" and "softer" to adjust volume the
amount I would like. What can I do to reduce the number of times I
need to repeat these words?
A. See Fast Volume, page 19. Fast Volume is a unique inVoca
feature designed to adjust your volume with just one command.
Q. inVoca appears to have difficulty hearing me unless I speak very
loudly.
A. If it is impractical to hold inVoca closer to your mouth, and
turning down the television volume does not help, you should try
adjusting the microphone sensitivity control, located inside the battery
compartment. See Page 21.
Q. inVoca keeps responding to words it hears on the television or in
background conversations.
A. If it is impractical to turn down the television volume, you should
try adjusting the microphone sensitivity control, located inside the
battery compartment. See Page 21. If this does not help, you should
turn on the Word Spotting feature described on page 33.
Alternatively, you may also try turning on Auto-Mute, described on
page 25.
Q. I pressed the [Wake_up] button, but inVoca does not respond to
voice commands.
A. inVoca will not respond to any voice commands until it has been
trained.
Q. Is there anyway to make the inVoca stop listening for commands
after I press the [Wake_up] button?
A. If you press the [Wake_up] button after inVoca is already awake,
it will put the inVoca back into the sleep mode.
Q. When I first received my inVoca, I trained it with a lot of trial
commands. Now I want to start over. Is there an easy way to erase
everything I did.
A. See "Erasing inVoca's Programming," page 21.
inVoca User Guide - Page 40
Q. When I try to use the inVoca remote, nothing happens, and the
LED does not flash.
A. Check to make sure that the batteries are good and have been
correctly installed. Refer to the Battery Installation section of the
manual.
Q. After I program the inVoca remote, it does not work with my
entertainment device.
A. You probably didn't select the correct device code. Refer to the
Detailed Programming section of the manual. If problems persist,
refer to the Auto Search feature.
Q. I tried all the methods, but I still couldn't program the remote
correctly, and I don't see my brand of entertainment device listed in
the code list.
A. Your entertainment device may not be supported by the inVoca
remote. Call the customer support number: 1 (800) 200-7700.
Q. The remote is acting erratically.
A. The batteries are probably too weak. Refer to the Battery
Installation section and replace them.
Q. Where can I find more helpful hints about my inVoca?
A. Visit the inVoca Web site at www.invoca.com.
Q. My TV takes a long time to change channels after I tell it to go to
a specific channel.
A. Some TVs require a channel number to be followed by "Enter." If
yours is one of these, make sure you have entered the channel number
and then the "Enter" button when training macros.
Q. When using the SCAN function, sometimes I have trouble getting
the scanning to stop.
A. inVoca cannot respond to your voice while it is busy sending
channel commands to the TV etc. Wait until the LED is no longer red
to tell inVoca to stop the scanning action.
To Next Page
Loading...
