Copyright 2018, InnovaPrep LLC Patented https://www.innovaprep.com/patents
Elution Fluid (Foam) Canister – Each canister contains enough elution fluid for up to 30 elutions.
Maintenance Tip – This reusable component is installed in the Tip Interface Port during the Start Up, Shut Down, and
Prime Maintenance Protocols. It is stowed on the bracket located on the right side of the instrument. DO NOT USE
WITH THE ELUTE OR RUN PROTOCOL - DAMAGE CAN OCCUR TO THE INSTRUMENT.
Storage Fluid with Adapter – This assembly is for use with the Shut-Down protocol. It conveniently stows on the
bracket located on the right side of the instrument.
Canister Interface Port – This spring-loaded port keeps the proper pressure on the valve of the fluid canister
(sometimes referred to as Can); it contains a check valve, which keeps the instrument pressurized when changing
canisters. The Storage Fluid Adapter also interfaces with this port during the Shut Down Maintenance Protocol.
Control Panel – The LCD display is navigated by the Up ( ▲ ), Down ( ▼ ), and Enter (
⏎
) keys. Certain menus may
also be entered by pressing and holding Enter (
⏎
) down for approximately 1 second.
Sample Platform – The sample container is placed here during sample processing.
FIGURE 3.2 INSTRUMENT COMPONENTS – LEFT SIDE
To Next Page
Loading...
