Copyright 2018, InnovaPrep LLC Patented https://www.innovaprep.com/patents
the System Settings. Advanced settings will be shown if Protocol: Adv has been previously selected in the System
Settings. This process is described in Section 5.4 The Instrument Settings Menu.
Step 2 – Using the Up arrow ( ▲ ) and Down arrow ( ▼ ) you can now go to each setting listed under the Protocol
name and then select the setting that you wish to change by pressing Enter (
⏎
). The Up arrow ( ▲ ) and Down
arrow ( ▼) are then used to change the setting as desired and Enter (
⏎
) is used to enter the setting into the
protocol.
Step 3 – When all changes to the protocol have been made select Save & Return. The user is then returned to
the Protocol Setup menu.
Step 4 – Select Select Protocol. The user is now able to select and run the created Protocol.
8.6 EDITING A CUSTOM PROTOCOL
Custom protocols can be edited after creation.
Step 1 – Advance to the Select Protocol Menu and select the name of the custom protocol and hold Enter (
⏎
).
A menu will appear that displays the protocol name at the top of the screen followed by standard or advanced
settings for the protocol below. Standard settings will be shown if Protocol: Std has been previously selected in
the System Settings. Advanced settings will be shown if Protocol: Adv has been previously selected in the System
Settings. This process is described in Section 5.4 The Instrument Settings Menu. Make the needed edits.
Step – 2 Select Save & Return. The user is then returned to the Protocol Setup menu.
8.7 DELETING A PROTOCOL
Step 1 – From the Run Protocol menu select FLAT (or the last protocol name). This will advance you to the
Running Protocols menu.
Step 2 – Select Delete Protocol. If custom protocols have been created, Using the Up arrow ( ▲ ) and Down
arrow ( ▼ ) you may now go to each available Protocol and then select the desired Protocol for deletion by
pressing Enter (
⏎
). Select Return to be returned to the Run Protocol menu.
8.8 PASSWORD PROTECTION
In order to allow users to control the creation, modification, or deletion of custom protocols, a password protection is
provided with the CP Select. Passwords can be setup by selecting Systems Settings>Set Password from the Main Menu.
If a password has not been previously set up then the user will see the Set Password screen and can create a password.
Using the Down arrow ( ▼ ) on the control panel to cycle through numerical and alpha characters sequentially from 1-9
followed by A-Z. The Up arrow ( ▲ ) will cycle through these options backwards. To select a character, press Enter (
⏎
).
Advance to the next menu by pressing and holding Enter (
⏎
). If a password was previously created then the user will see
the Old Password screen and will be required to enter the password before updating to a new password or deleting the
old password. To delete the password, simply do not enter any characters and then press and hold Enter (
⏎
).
Once a password is set, you cannot edit, delete or create new protocols without the password. You can run the custom
protocols and factory set protocols without the password. You cannot turn the password function off without the
password. It is possible to perform a Reset Defaults function to remove the password function without a password
however; doing so will remove all custom protocols. Custom protocols lost by the Reset Defaults function are not
To Next Page
Loading...