Innovative Neutronics WalkAide - Wearing Schedule and Break-In; Break-In Period Schedule; Skin Integrity Checks During Wear; Skin Preparation for Wearing

21
7.0 Wearing Schedule
Helpful Hints to Enhance the Break-In Period
• Remove the WalkAide system every 2 hours to check skin integrity.
• Slowly work into full-time wearing of the WalkAide system.
• Remove the cuff at regular intervals and inspect the skin under the
electrodes. These areas will be pink due to increased blood flow
under the electrodes.
• DO NOT use lotions or oils to soften the skin. Make sure the skin is
clean and try prior to applying the cuff.
• If desired, shaving the leg should be done in the evening to prevent
potential irritation during daily wear.
• If soreness or irritation occurs in the area under the electrodes,
reduce the wearing time and contact your WalkAide clinician.
• Wet the electrodes with plenty of water before applying the cuff.
Make sure you change the electrodes approximately every 1-2
weeks, and cover them each night with the plastic backing tabs.
ON Time OFF Time
Days 1-3 15-60 minutes 30 minutes
Days 4-6 1-3 hours 30 minutes
Days 7-9 3-5 hours 30 minutes
Days 10-12 5-6 hours 1 hour
Days 13-14 6-8 hours 1 hour