INOV8 Model F240 – Edited September 2008
1
L
ISTING AGENCIES
This equipment is tested and listed by Intertek ETL Semko (ETL) - an internationally
recognized third party test agency to UL 296A - Standard for Safety for Waste Oil
Burning Air-Heating Appliances, Edition 2, Revision 2006/03/08 (the U.S. used oil
standard), and to CSA B140.0 General Requirements for Oil Burning Equipment General
Instruction No 2-4 (R1991) Rev: 1991/01/01and is listed with the European Economic
Community with a CE registration number 3884/97. The INOV8 tanks are also tested
and listed by ETL to UL 80 Standard for Steel Tanks for Oil-Burned Fuel.
FUELS- GENERAL INFORMATION
This product is approved to burn the following oils: crankcase oil, crankcase oil with up to
20% gasoline, fuel oils up to #6 heating oil, jet fuel, mineral spirits and transmission oil.
The following additional oils have been tested and passed combustion analysis
requirements but are not approved as fuels due to a lack of standards to define them:
used and crude vegetable oil, and biodiesel. DO NOT attempt to burn other liquids
without written authorization from INOV8 International, Inc. Only used oil generated on
the premises of the owner may be used in this equipment, unless written authorization is
obtained from the regulatory authority.
Caution – used oils may contain gasoline, heavy metallic compounds and foreign
materials. When burned, these compounds are emitted from or deposited within this
furnace and therefore care should be taken when storing these oils or when using,
cleaning and maintaining this equipment.
SPECIAL PRECAUTIONS!
1. This furnace is listed for commercial or industrial use only. It may not be used for
residential or any other unauthorized purpose.
2. All furnaces must be wired strictly in accordance with wiring diagram and
instructions in this manual.
3. Disconnect the power supply before making wiring connections to prevent
electrical shock and equipment damage.
4. Disconnect the power supply before cleaning the furnace.
5. Do not install furnace or chimney connector closer than 18 inches to combustible
materials in any direction, except the louver side of the furnace, which must be
unobstructed.
6. DO NOT add fluids with the classification of a hazardous waste, or fuels with
flash points below 100
o
F (such as gasoline) to your used oils. (Check your local
codes for restrictions.)
7. For your protection - DO NOT store or use gasoline or other flammable vapors
and liquids in the vicinity of this or any other appliance.
8. Canadian standards allow only used oil generated on the premises of the owner
to be used as fuel, unless permitted by the regulatory authority.
9. Venting - Failure to provide proper venting could result in death, serious injury,
and/or property damage. Units must be installed with a flue connection, draft
regulator and proper vent to the outside of the building. Safe operation of any
gravity vented heating equipment requires a properly operating vent system,
correct provision for combustion air, and regular maintenance and inspection.
10. Hazardous Atmosphere - The INOV8 products are not designed for use in
hazardous atmospheres containing flammable vapors or combustible dust, or
atmospheres containing chlorinated or halogenated hydrocarbons.
To Next Page