Inovance MD500T22GB-INT - Remove and Refit the Front Cover

2. Mechanical Installation
- 27 -
2
2.5 Remove and Ret the Front cover
You must remove the front cover before performing electrical installation
WARNING
● Ensure the drive power-off time exceeds 10 minutes before removing the cover.
● Be careful when removing the front cover. A falling cover may cause damage to the
drive or personal injury.
■
Remove and Ret the Front Cover of a Plastic Housing
Removal
Pinch inwards on the latch
on both sides of the cover to
release the cover .
1
3
2
Hold the lower part of the front cover.
3
Lift the front cover.
1
2
Retting
1
1
Locate the cover top at its fixing position.
2
Align the front cover to the drive and
push it down in the arrow direction
until the side latches are in place.
2