Inovance MD500T75GB-INT - Page 238

8. Peripherals and Options
- 237 -
8
Jumper Description Meaning Setting
J3 AO2 output
selection: voltage
or current
Voltage
Current
J1 RS485 terminal
resistor matching
selection
Matching the terminal
resistor
Not matching the
terminal resistor
J7 Run/Stop
selection
Run
Stop
J8 OP1 connecting
mode selection
If DI connected in
SINK mode, OP1
connected to +24V
If DI connected in
SOURCE mode, OP1
connected to COM
S1 AI3, PT100,
PT1000 selection
AI3: 1, 2, 3 set to ON
ON
PT1000: 4, 5, 6 set to
ON
ON
PT100: 6, 7, 8 set to
ON
ON
Note
Setting of jumpers takes top view with main terminals at the bottom of the
card as visual angle. Jumpers are silk-screened on the card.