Inovance MD520-4T2.2BS - Guide Rail; Installing the UVW Output Copper Busbar

Options
‑51‑
Figure 5‑12 Dimensions of bottom mounting bracket for T12 models (mm)
Note
● The bottom installation bracket applies to the PS standard cabinet, which is
classified into two types: 800 mm (width) x 600 mm (depth) and 800 mm (width) x
800 mm (depth). The size described in the figure applies to the PS standard
cabinet with 800 mm (width) x 800 mm (depth).
● The bottom installation bracket for T10 to T12 models applies only to the PS
standard cabinet with 800 mm (width) x 600 mm (depth). To apply to the PS
standard cabinet with 800 mm (width) x 800 mm (depth), contact Inovance.
5.2.3 Guide Rail
For details of the guide rail, see Operation Instructions for MD500‑AZJ‑A3T10 Guide
Rail
.
5.2.4 Installing the UVW Output Copper Busbar
All MD520 models excluding that with the base (‑L) are delivered with the UVW output
copper busbar. To install the UVW output copper busbar, do as follows:
1. Use the screwdriver or cutting pliers to remove the three knockouts.