Inovance MD800 Series - Page 125

Commissioning and Trial Run
‑124‑
Parameter
No.
Communication
Address
Parameter Name Setting Range Default Unit Property
U0‑13 28685 Length value 1–65535 Model
dependent
‑ Modification
prohibited
U0‑14 28686 Load speed display 0 to Rated motor speed Model
dependent
‑ Modification
prohibited
U0‑15 28687 PID reference 0–65535 Model
dependent
‑ Modification
prohibited
U0‑16 28688 PID feedback 0–65535 Model
dependent
‑ Modification
prohibited
U0‑17 28689 PLC stage 0–15 Model
dependent
‑ Modification
prohibited
U0‑19 28691 Feedback speed 0.00 Hz to Maximum
frequency
Model
dependent
Hz Modification
prohibited
U0‑20 28692 Remaining running
time
0.0–6500.0 Model
dependent
min Modification
prohibited
U0‑21 28693 AI1 gain and voltage
after offset
‑10.00 V to +10.00 V Model
dependent
V Modification
prohibited
U0‑22 28694 AI2 gain and voltage
after offset
‑10.00 V to +10.00 V Model
dependent
V Modification
prohibited
U0‑23 28695 AI3 gain and voltage
after offset
‑10.00 V to +10.00 V Model
dependent
V Modification
prohibited
U0‑24 28696 Linear speed 0–65535 Model
dependent
m/
min
Modification
prohibited
U0‑25 28697 Current power‑on
time
0–65000 Model
dependent
min Modification
prohibited
U0‑26 28698 Current running time 0.0–6500.0 Model
dependent
min Modification
prohibited
U0‑28 28700 Communication
setting value
‑100.00% to +100.00% Model
dependent
% Modification
prohibited
U0‑30 28702 Main frequency X
display
0.00–500.00 Model
dependent
Hz Modification
prohibited
U0‑31 28703 Auxiliary frequency Y
display
0.00–500.00 Model
dependent
Hz Modification
prohibited
U0‑33 28705 Synchronous motor
rotor position
0.0° to 359.9° Model
dependent
° Modification
prohibited
U0‑35 28707 Target torque (%) ‑200.0% to +200.0% Model
dependent
% Modification
prohibited
U0‑37 28709 Power factor angle 0.0° to 6553.5° Model
dependent
° Modification
prohibited
U0‑39 28711 Target voltage upon
V/f separation
0 V to Target voltage Model
dependent
V Modification
prohibited
U0‑40 28712 Output voltage upon
V/f separation
0 V to Output voltage Model
dependent
V Modification
prohibited
U0‑41 28713 DI state display 0–65535 Model
dependent
‑ Modification
prohibited