Preparations Before Installation
‑16‑
Tool
Description Diagram
Tape measure
Used to measure the mounting
dimensions of the AC drive
during installation.
Gloves Used to prevent static
electricity during mechanical
installation.
M4x12 cross recessed
pan head SEMS screws
(with flat washer and
spring washer)
Power supply unit: 4 PCS per
unit
Drive unit: 2 PCS per unit
Filter unit: 2 PCS per unit
‑
Wiring tool (standard
for the power supply
unit)
Used to crimp the cables to
terminals.
The wiring tool is marked with
two current types. 55 A
corresponds to the input
terminals of the power supply
unit, and 30 A corresponds to
the output terminals of the
drive unit and braking
terminals.
EMC shielded brackets
(optional)
The EMC shielded brackets are
optional. The bracket for the
power supply unit is installed
on the input side of the power
supply unit, and the bracket for
the drive unit is installed on the
output side of the drive unit.
EMC shielded bracket for the
power supply unit
EMC shielded bracket for the
drive unit
To Next Page
Loading...
