Installation and Wiring
‑25‑
Note
● The wiring tool is required for connecting the power supply unit input terminal
and drive unit output terminals. The thick side of the tool is used for the power
supply unit and the thin side is used for the drive unit.
● The signal terminal, relay output terminal, external 24 V power input terminal, and
safe torque off (STO) terminal can be directly plugged in.
3. Insert the input terminal into the power supply unit.
Note
For models with an optional braking unit, the braking output terminal must be inserted.
4. Insert the output terminals into the drive unit.
Note
For models with an optional STO terminal, the STO terminal must be inserted.
To Next Page
Loading...
