Inovance Monarch NICE-L-C-2003 - Page 93

- 92 -
4 Parameter Description
4
Parameter
No.
Parameter Name Setting Range Default Unit
Property
F6-06
Service oors 2 (oors
17–32)
0 to 65535 65535 -
★
F6-35
Service oors 3 (oors
33–40)
0 to 65535 65535 -
★
These parameters are used to set the service oors among oors 1–40. F6-05 (Service oors 1) corresponds to
oors 1–16. F6-06 (Service oors 2) corresponds to oors 17–32. F6-35 (Service oors 3) corresponds to oors
33–40.
These parameters are set in the similar way.
The following part takes F6-05 as an example to describe how to set the service oors.
F6-05 is enabled through bit addressing.
The 16 bits of the parameter respectively correspond to 16 oors. If a bit is set to 1, the elevator will respond to
calls of this oor; if this bit is set to 0, the elevator will not respond to calls of this oor.
Figure 4-8 Converting binary value of F6-05 to decimal
0: Floor 1 not in service
1
: Floor 1 in service
1
0: Floor 2 not in service
1: Floor 2 in service
0: Floor 3 not in service
1: Floor 3 in service
0: Floor 4 not in service
1: Floor
4 in service
0: Floor 5 not in service
1
: Floor 5 in service
0: Floor 6 not in service
1: Floor 6 in service
0: Floor 7
not in service
1: Floor 7 in service
0: Floor 8 not in service
1: Floor 8 in service
0: Floor 9 not in service
1: Floor 9 in service
0: Floor 12 not in service
1: Floor 12 in service
0: Floor 13 not in service
1: Floor 13 in service
0: Floor 14 not in service
1: Floor 14 in service
0: Floor 15 not in service
1: Floor 16 in service
0: Floor 16 not in service
1: Floor 16 in service
2
4
8
16
32
64
128
256
512
1024
2048
4096
8192
16384
32768
Bit2
Bit1
Bit3
Bit4
Bit5
Bit6
Bit7
Bit8
Bit9
Bit10
Bit11
Bit12
Bit13
Bit14
Bit15
Bit0Bit11 Bit1Bit2Bit3Bit4Bit5Bit6Bit7Bit8Bit9Bit10Bit12Bit
13Bit14Bit15
1612 2481632641282561024204840968192
Bit Addressing
Binary Addressing 1638432768
Floor 1
Floor 2
Floor 3
Floor 4
Floor 5
Floor 6
Floor 7
Floor 8
Floor 9
Floor 10
Floor 11
Floor 12
Floor 13
Floor 14
Floor 15
Floor 16
Floor number indicated by
each bit
Convert binary value to
decimal, and set this decimal
on the operation panel
0: Floor 11 not in service
1: Floor 11 in service
0: Floor 10 not in service
1: Floor 10 in service
Meaning of the binary value
Bit
0