Inovance Monarch NICE-L-C-2003 - Page 96

- 95 -
4 Parameter Description
4
Parameter
No.
Parameter Name Setting Range Default Unit
Property
F6-11
Elevator function
selection
Bit1: Disabling returning to base
oor for verication
Bit2: Cancelling auto sequential
arrange of hall call oor addresses
to be displayed
Bit5: Current detection valid at
startup for synchronous motor
Bit6: Reversing MCB lamp output
Bit7: Door open valid at non-door
zone in the inspection state
Bit8: Door open and close once
after inspection turned to normal
Bit10: Buzzer not tweet upon re-
leveling
Bit11: Super short oor function
Bit12: Fault auto reset
Bit13: E53 fault auto reset
Bit14: Up slow-down not reset for
super short oor
Bit15: Down slow-down not reset
for super short oor
8448 -
★