Inovance SV670N Series - Description of Warning Codes; Parameter, Encoder, and Communication Warnings

Description of Warning Codes
‑14‑
3 Description of Warning Codes
● E108.0: Parameter write error
Cause:
Parameter values cannot be written to e2prom.
Cause
Confirming Method
Solution
An error occurs during
parameter‑writing.
Modify a certain parameter,
power off and on the servo
drive again and check
whether the modification is
saved.
If the modification is not
saved and the fault persists
after the servo drive is
powered off and on
repeatedly, replace the
servo drive.
● E108.1: Parameter read error
Cause:
Parameter values cannot be read from e2prom.
Cause
Confirming Method
Solution
The parameter‑read
operation is abnormal, and
the system indicates an
e2prom read error
Modify a certain parameter,
power off and on the servo
drive again and check
whether the modification is
saved.
If the modification is not
saved and the fault persists
after the servo drive is
powered off and on
repeatedly, replace the
servo drive.
● E108.2: Check on data written in e2prom failed
Cause:
The check on the data written in e2prom fails.
Cause
Confirming Method
Solution
An error occurs during
parameter‑writing.
Modify a certain parameter,
power off and on the servo
drive again and check
whether the modification is
saved.
If the modification is not
saved and the fault persists
after the servo drive is
powered off and on
repeatedly, replace the
servo drive.
● E108.3: Check on data read in e2prom failed
Cause:
The check on the data read in e2prom fails.