Description of Warning Codes
‑24‑
Cause
Confirming Method
Solution
6. The motor is stalled due
to mechanical factors,
resulting in overload during
operation.
Check the reference and the
motor speed (H0b.00)
through the software tool or
the keypad.
● References in the position
control mode: H0b.13
(Input position reference
counter)
● References in the speed
control mode: H0b.01
(Speed reference)
● References in the torque
control mode: H0b.02
(Internal torque reference)
Check whether the reference
value is not 0 or is very large
but the motor speed is 0
RPM in the corresponding
mode.
Eliminate the mechanical
factors.
7. The servo drive is faulty.
Power off and on the servo
drive again.
Replace the servo drive if the
fault persists after the servo
drive is powered off and on
again.
● E910.0: Control circuit overvoltage
To Next Page
Loading...
