14
4. Calibration and Parameter
setting
4.1 Enter setting
There have two methods to enter the setting menu:
1. Put the switch “MARK” to “On” position, enter calibration
And when calibration is finish. Put the switch “ MARK” to “off” position.
Then add the sealing screw at the back of indicator.
2. when the switch “ MARK” is on position, press the “ ” hold it
and then press” ” enter calibration.
The key functions in setting：
ENTER
UP
DOWN
LEFT
RIGHT
BACK
EXITCALIBRATION
POWER
To Next Page
Loading...