Insignia Flex NS-P10A8100 - Getting Started with Your Tablet; Battery Charging and Initial Setup

Status items
Swipe down from the top edge of the screen with two fingers.
OR
Open notifications, then swipe down again.
Get started
This section has resources to help you start using your tablet right away. You can
also check out Features (on page5) to familiarize yourself with your new tablet.
For more information about using and customizing your tablet, see Understand
the basics (on page12) and Change basic settings (on page22).
Charge the battery
Charge your tablet fully (4.5 hours) before using it the first time. After the first
time, charge your battery when it is less than 15% full.
1
Insert the micro USB cable into your tablet's micro USB port.
2
Insert the other end into the wall charger, then connect it to a power outlet.
Note:It takes about 4.5 hours to fully charge your tablet.
www.insigniaproducts.com
NS-P10A8100
10