Insignia NS-24DD220NA16 - Customizing TV Settings; Restoring Settings to the Defaults

72
24"/28"/32" 720p 60Hz, LED DVD combo TV
www.insigniaproducts.com
9 When the update is complete, unplug the USB
flash drive, then press OK. Your TV turns off then
on to complete the update.
10 If the channel list has been deleted, you need to
scan for channels. For more information, see
“Automatically scanning for channels” on page 56.
Customizing TV settings
If you did not complete the customizing part of the
Easy Setup wizard the first time you turned on your TV,
you can run the wizard again to customize settings.
When you run the Easy Setup wizard, your TV will not
reset any changes you made on the Picture, Audio,
Channels, or Settings menu. The wizard scans for
channels and replaces the channel information stored
on your TV.
1 Press TV-MENU.
2 Press
W or X to highlight HELP, then press T or
OK.
3 Press
S or T to highlight Customize my TV, then
press OK or
X. A message asks if you want to run
the Easy Setup wizard.
4 Press
S or T to select OK (to reset) or Cancel (to
not reset), then press OK.
If you select OK, your TV turns off, then turns on
again. The Easy Setup wizard opens. Go through
the Easy Setup wizard. For more information, see
“Turning on your TV for the first time” on page 37.
OR
If you select Cancel or press TV-MENU, your TV
returns to the Help menu without making any
changes. If you press EXIT, the on-screen menu
closes without making any changes.
Restoring settings to the defaults
When you restore default settings, all the settings you
have customized (except parental controls) are reset.
1 Press TV-MENU.
2 Press
W or X to highlight HELP, then press T or
OK.
3 Press
S or T to highlight Reset to Default, then
press OK or
X.
4 Press
S or T to select OK (to reset) or Cancel (to
not reset), then press OK.
If you select OK, your TV turns off, then turns on
again. Go through the Easy Setup wizard. For more
information, see “Turning on your TV for the first
time” on page 37.
OR
If you select Cancel or press TV-MENU, your TV
returns to the Help menu without making any
changes.
OR
If you press EXIT, the on-screen menu closes
without making any changes.
Note
• If you see a message that says the
firmware file is incorrect, make sure
that you have downloaded the correct
file for your model.
• If you see a message that says the
update failed or the TV screen is blank
and the power LED is blinking red
then blue, turn off your TV, turn it back
on, then run the upgrade again.