Insignia NS-46E440NA14 - Using Analog Audio

32
Insignia 46" LED TV
www.insigniaproducts.com
Using analog audio
When you connect a home theater to the /AUDIO OUT jack, the TV speakers are muted.
To connect a home theater system using analog audio:
1 Make sure that your TV’s power cord is unplugged and the home theater system is turned off.
2 Connect a 3.5mm audio cable (not provided) to the /AUDIO OUT jack on the back of your TV and to the
AUDIO IN jacks on the analog home theater system.
3 Plug your TV’s power cord into a power outlet, then turn on your TV and the home theater system.
Note
• For information about selecting the audio out mode for a home theater,
see the “Headphone/Audio Out“ option in “Adjusting sound settings”
on page 45.
• You can connect headphones, an amplifier, a home theater system, or a
sound bar to the /AUDIO OUT jack. If you want to use headphones,
you need to disconnect the amplifier, home theater system, or sound
bar.
3.5mm audio cable
Home theater system
Back of TV
3.5mm audio
cable connector
/AUDIO OUT
jack
On your TV