7
1.6 Cu. Ft. 12 Volt Compact Refrigerator
www.insigniaproducts.com
Installing your refrigerator
Before using your refrigerator
• Remove the exterior and interior packing.
• Let your refrigerator stand upright for approximately four hours before
connecting it to power. This reduces the possibility of a malfunction in the
cooling system from incorrect handling during transportation.
• Clean the interior surface with lukewarm water using a soft cloth.
Finding a suitable location
• Place your refrigerator on a floor that’s strong enough to support your
refrigerator when it is fully loaded.
• Allow 1 in. (2.5 cm) of space between the back and sides of your refrigerator
and any surrounding walls. This allows the correct air ventilation. Adjust the
feet to keep your refrigerator level.
• Locate your refrigerator away from direct sunlight and sources of heat (stove,
heater, radiator, and so on). Direct sunlight may affect the acrylic coating and
heat sources may increase electrical consumption. Ambient temperature
below 50° F (10° C) or above 85° F (29.4° C) hinders the performance of your
refrigerator. Your refrigerator is not designed for use in a garage or any other
outside installation.
• Avoid locating your refrigerator in moist areas.
Minimum space requirements
CAUTION: Your refrigerator is not designed for a recessed installation.
Note: The door should protrude at least 1 in. (2.5 cm) beyond the surrounding
cabinets.
19.5 in. (49.5 cm) min.
20.5 in. (52.1 cm) min.
20.8 in. (52.8 cm) min.