20
www.insigniaproducts.com
STEP 8 (Optional): Attaching the cabinet to a supporting wall
You n e ed:
1 Move the assembled cabinet up against the wall where it will be placed, then mark the position of the two holes in
the back panel on the wall.
2 Move the assembled cabinet away from the wall and drill where the two holes are marked, then insert anchors (H)
into the holes.
3 Move the assembled cabinet back to the wall, aligning the holes in the back panel with the installed anchors, then
attach the cabinet to the wall with the two 5 x 50 mm screws (B) through the two holes in the back panel.
B
5 x 50 mm screws (2)
Phillips screwdriver
Drill with M8 bit
H
Anchors (2)
To Next Page
Loading...
