Insignia NS-FCBN3 - STEP 13: Installing the File Bars and Extrusions

27
2-Drawer File Cabinet - Dark Oak
www.insigniaproducts.com
STEP 13: Installing the file bars and extrusions
You n e ed:
1 Fit two file side extrusions (P) to the sides of the upper drawer and push them into place, then fit the file back
extrusion (Q) to the back of the upper drawer and push it into place.
2 (Optional for letter size files) place the file bar (R) in between the file rails on the front and back of the drawer.
3 Repeat for the lower drawer (the drawer with the plastic bracket on the upper portion of the drawer).
P
File side extrusion (4)
R
File bar (2)
Q
File back extrusion (2)
Note: Upper drawer
with the plastic
bracket on the lower
portion of the drawer