11
2.0 Channel Soundbar
www.insigniaproducts.com
Using the remote control
Point the remote control directly at the IR sensor on the front of your soundbar.
You must be within approximately 50 ft. (15m) of your soundbar and within 30° on
either side.
Installing the remote control batteries
1 Remove the battery compartment cover from the back of the remote control.
2 Insert two AAA batteries into the battery compartment, making sure that the
polarity on the batteries matches the + and - symbols inside the battery
compartment.
3 Replace the battery compartment cover.
Programming another remote control
IR remote learning function (optional)
Your soundbar can learn 12 button codes from most remote controls, so you can
easily control the sound with both the soundbar remote and the TV remote. You
can also replace the soundbar remote with another remote.
Programming using the Manual Sequence Learning mode:
1 Point your soundbar’s remote control and the remote you want to program
within 4 inches (10 cm) of the remote control sensor on your soundbar.
2 Press and hold the soundbar’s button (on the right side button panel, not
on the remote) from standby for five seconds to turn on the Manual Sequence
Learning mode. The Status indicator blinks red rapidly and the soundbar starts
to learn.
3 Short press the button on your soundbar’s remote control that you want the
other remote control to learn. The Status indicator blinks blue once.
CAUTIONS:
• Do not spill water or any liquid on the remote control.
• Do not place the remote control on a wet surface.
• Do not place the remote control in direct sunlight or near sources of
excessive heat.
• If the remote control is not going to be used for a long time, remove the
batteries to avoid any damage that may be caused by leakage and corrosion.
Note: If the status indicator blinks orange, your soundbar can't learn the button
code. Try another button or another remote control.
To Next Page
Loading...
Need help?
General
