18
3-in-1 TV STAND
www.insigniaproducts.com
Step 2: Determine whether your TV has a flat back or an irregular or obstructed
back or a curved screen
1 Carefully place your TV screen face-down on a cushioned, clean surface to protect the screen from damages
and scratches.
2 If your TV has a table-top stand attached, remove the stand. See the documentation that came with your TV for
instructions.
3 Temporarily lay the TV brackets (P) vertically on the back of your TV.
4 Align the screw holes in the TV brackets with the mounting screw holes on your TV.
5 Identify which type of back your TV may have:
• Flat back: The brackets lay flush against the back of your TV and do not block any jacks. You do not need spacers
when assembling the wall mount.
• Obstructed back: The brackets block any of the jacks on the back of your TV. You will need spacers when
assembling the wall mount.
• Irregularly-shaped back or curved screen TVs: There is a gap between the bracket and some part of the back of
your TV. You will need spacers when assembling the wall mount.
6 Remove the brackets.
NS-HWMC1848_17-0157_MAN_V4_ENG.fm Page 18 Tuesday, March 7, 2017 3:08 PM
To Next Page
Loading...
