19
3-in-1 TV STAND
www.insigniaproducts.com
Step 3
:
Option 1 - Mounting bracket instructions for a TV with a flat back
To mount the TV brackets:
1 Insert the selected bolts through the washers and proper mounting holes on the TV brackets (P) (for the 100 x
100 mm vesa pattern you’ll need to lift the bracket hangers to insert the screws), then finger tighten them into
the threaded holes on the back of your TV. Make sure the TV brackets are centered and level with each other
and the hooks face the bottom of the TV.
NOTE: Lean the TV up against a wall or other solid surface when attaching with the TV brackets. DO NOT place the TV
face down on the glass, this may cause permanent damage.
2 Tighten the bolts until they are snug against the TV bracket using a Phillips screwdriver. DO NOT over tighten.
JJ LL NN PP
ZZ
UU VVTT
UU VVTT
YY
SS
ZZ
HH
YY
SS
JJ LL NN PPHH
JJ LL NN
UU VV
ZZ
TT
PPHH
SS
YY
or
or
or
or
or
or
or
or
or
Installing the mounting brackets for the 100 x 100 mm vesa hole pattern
You’ll need:
HH (4)
or
or
or
Bolts & Washers
JJ (4)
LL (4)
NN (4)
SS (4)
TT (4)
UU (4)
VV (4)
or
or
or
YY (4)
ZZ (4)
or
Phillips screwdriver
Level
P TV brackets (2)
PP (4)
or
NS-HWMC1848_17-0157_MAN_V4_ENG.fm Page 19 Tuesday, March 7, 2017 3:08 PM
To Next Page
Loading...
