Insignia NS-HWMC1848 - Option 2 - Mounting bracket instructions for a TV with an irregularly shaped or obstructed back or curved screen TVs.

20
3-in-1 TV STAND
www.insigniaproducts.com
Step 3 : Option 2 - Mounting bracket instructions for a TV with an irregularly
shaped or obstructed back or curved screen TVs.
1 Insert the selected bolts through the washers and proper mounting holes on the TV brackets (P) (for the 100 x
100 mm vesa pattern you’ll need to lift the bracket hangers to insert the screws), then finger tighten them into
the threaded holes on the back of your TV. Make sure the TV brackets are centered and level with each other
and the hooks face the bottom of the TV.
NOTE: Lean the TV up against a wall or other solid surface when attaching with the TV brackets. DO NOT place the TV
face down on the glass, this may cause permanent damage.
2 Tighten the bolts until they are snug against the TV bracket using a Phillips screwdriver. DO NOT over tighten.
JJ LL NN PP
JJ LL NN PP
YY
YY ZZ
UU VVTT
TT
WW
XX
HH
SS
WW
UU VV
HH
ZZ
SS
XX
WW
ZZ
KK MM QQ RR
TT
UU
VV
XX
YY
II
SS
or
or
or
or
or
or
or
or
or
or
or
or
or
Installing the mounting brackets for the 100 x 100 mm vesa hole pattern
You’ll need:
II (4)
or
or
Bolts & Washers
KK (4)
MM (4)
QQ (4)
SS (4)
TT (4)
UU (4)
VV (4)
or
or
or
YY (4)
ZZ (4)
or
Phillips screwdriver
Level
P TV brackets L/R (2)
XX (4)
WW (4)
or
or
RR (4)
NS-HWMC1848_17-0157_MAN_V4_ENG.fm Page 20 Tuesday, March 7, 2017 3:08 PM