27
3-in-1 TV STAND
www.insigniaproducts.com
Step 2: Attach the swivel bracket
1 Align the swivel bracket (M) at the height you would like the center of your TV to be.
2 Insert a 2¼” bolt (V), with a lock washer (W) and a flat washer (X), through the swiveling bracket (N) and the
long rear support (C).
3 Place a second flat washer (X) and a lock washer (W) onto the end of the threaded bolt, then finger tighten a hex
nut (Y) onto the bolt.
4 Repeat this procedure for the three remaining holes.
5 Securely tighten with the open end wrench (DD) and 4 mm hex key (EE).
NOTE: The swivel bracket allows your TV to swivel from side to side, but will not allow your TV to tilt up or down.
You’ll need:
V (4)
W (8)
X (8)
Y (4)
DD (1)
EE (1)
NS-HWMC1848_17-0157_MAN_V4_ENG.fm Page 27 Tuesday, March 7, 2017 3:08 PM
To Next Page
Loading...
