3
6-Quart Multi-Cooker
www.insigniaproducts.com
IMPORTANT SAFETY INSTRUCTIONS
When using a multi-cooker, basic precautions should always be followed,
including the following:
READ ALL INSTRUCTIONS BEFORE USING
1 Do not touch hot surfaces - use handles.
2 To avoid the risk of electric shock, do not immerse the multi-cooker or
cord in water or other liquids.
3 Keep the multi-cooker away from children to avoid accidents. Close
supervision is necessary when any appliance is used by or near
children.
4 Unplug from the wall outlet when not in use or before cleaning. Allow
to cool before installing or removing parts and before cleaning.
5 Do not operate the multi-cooker with a damaged cord or if the
multi-cooker has been dropped or damaged. To avoid the risk of
electric shock, do not disassemble the multi-cooker. Take it to a
qualified serviceman for examination and repair. Incorrect assembly
might result in a risk of electric shock when the multi-cooker is used
after reassembly.
6 Use of accessories not recommended by the manufacturer may cause
injuries.
7 Do not use outdoors.
8 Do not let the cord hang over the edge of a table or counter, or touch
hot surfaces.
9 Do not place on or near a gas or electric burner or an oven. Never put
the whole appliance in a dishwasher (only the inner cooking pot is
dishwasher safe).
10 Use extreme caution when moving an appliance containing hot oil or
other hot liquids.
11 To disconnect, turn off, then remove the plug from the wall outlet.
12 Only use this multi-cooker for its intended purpose.
13 This appliance is for household use only.
14 Caution - to reduce the risk of electric shock, cook only in the included
inner cooking pot.
15 Do not place the unit on an unstable surface or on a surface that might
block the vent hole on the bottom, such as newspapers or foam.
16 Do not use this multi-cooker in a location near water or fire, or in a
place exposed to direct sunlight or splashing oil.
17 Put the appliance in a place out of reach of children.
NS-MC60SS8_17-0691_MAN_V1_ENG.fm Page 3 Tuesday, September 12, 2017 11:32 AM
To Next Page
Loading...
