9
21 Cu. Ft. Top Mount Refrigerator
www.insigniaproducts.com
Using your refrigerator
Setting the refrigerator temperature
• The first time you turn the refrigerator on, the control panel LEDs turn on for
three seconds, then displays the current setting (default = 3). Your refrigerator
runs continuously for several hours until it reaches the preset temperature.
After your refrigerator is fully cooled, you can adjust the temperature up or
down to your personal preference.
• To temporarily suspend cooling in the refrigerator and freezer, press and hold
the SET button for three seconds. The STANDBY LED turns on and cooling is
turned off. Press the SET button again to cancel standby mode and resume
cooling.
# ITEM DESCRIPTION
1SET button
Press to change the refrigerator setting from 1 (cold) to 5
(coldest).
2 LED indicators Light to show the current refrigerator setting.
3 STANDBY LED
Lights to indicate when the refrigerator is in standby mode
(refrigerator and freezer are turned off ).
Notes:
• If the refrigerator is unplugged or loses power, you must wait three to five
minutes before restarting it. If you attempt to restart before this time delay,
the refrigerator will not start.
• Large amounts of food will lower the cooling efficiency of the refrigerator.
• If you choose to change the thermostat setting, adjust it by one increment at
a time. Allow 24 hours for the temperature to stabilize between adjustments.
To Next Page
Loading...
Need help?
General
