www.insigniaproducts.com
7
7 Cu. Ft. Convertible Upright Freezer
Interior
Setting up your freezer
Before using your freezer
• Remove the exterior and interior packaging.
• Wash the inside with a damp, warm cloth and a baking soda solution (two tablespoons in a quart [.94 l] of water), then
wipe dry with a dry cloth. Do this periodically to keep your freezer looking new.
• Level your freezer using the leveling feet. If you do not level your freezer, the door may not close or seal correctly,
causing cooling, frost, and moisture problems. Turn the leveling feet clockwise to raise or counterclockwise to lower a
side.
Finding a suitable location
• Place your freezer on a floor that is strong enough to support it when fully loaded.
• Do not install your freezer on carpeting or a rug.
• Your freezer is designed to be free standing and should not be recessed or built-in.
• Your freezer is garage ready (only in Freezer mode), and is designed to operate in an ambient temperature range of 0° F
(-17.7° C) to 110° F (43.3° C).
• Adjust the feet to keep your freezer level.
• If you locate your freezer next to a fixed wall, allow sufficient space on the hinge side for the door to swing open.
• Position your freezer away from direct sunlight and sources of heat, such as a stove, heater, or radiator. Direct sunlight
may affect the acrylic coating and heat sources may increase electrical consumption. Extremely cold temperatures may
also prevent your freezer from performing correctly.
• Avoid locating your freezer in moist areas.
• Your freezer is intended for household use only. It is not designed for outside installation, including anywhere that is
not temperature controlled, such as a porch.
CAUTION:
• This freezer is heavy (94.8 lbs. (43 kg)). We recommend that two people be used to move it.
• Before connecting this freezer to a power source, let it stand for approximately six hours to reduce the possibility of a malfunction in
the cooling system.
Crisper drawer
Temperature control
Glass shelves
Leveling feet
To Next Page
Loading...
Need help?
General