14
NS-WBRDVD2/NS-WBRDVD2-CA Wireless Blu-ray Disc Player
www.insigniaproducts.com
4 Press or to select the aspect ratio you want,
then press ENTER. You can select 16:9 Wide,
16:9 Pillarbox, 4:3 Pan and Scan, or 4:3 Letter
Box.
5 Press to go to the previous menu.
Turning film mode on or off
Movies are recorded on film at a rate of 24 pictures
(frames) per second. Many of the movies on Blu-ray
Discs are placed on the discs at this frame rate. If
your TV supports 24 frames per second, but you
would prefer viewing the video at a higher frame
rate, you should turn off Film Mode.
To turn film mode on or off:
1 Press or to select Settings, then press
ENTER. The Settings menu opens.
2 Press or to select Display, then press
ENTER. The Display menu opens.
3 Press or to select Film Mode (1080p24),
then press ENTER.
4 Press or to select Auto or Off, then press
ENTER. Off selects a 60 frames/second output
format. When the Film mode is set to Auto, the
output format will go to 24p automatically, if it's
supported.
5 Press to go to the previous menu.
Selecting Deep Color
Select 24 bits, 30 bits, or 36 bits.
To select Deep Color:
1 Press or to select Settings, then press
ENTER. The Settings menu opens.
2 Press or to select Display, then press
ENTER. The Display menu opens.
3 Press or to select Deep Color, then press
ENTER.
4 Press or to select Auto or Off, then press
ENTER. If Deep Color
is set to Auto, and the
player is connected to TV via HDMI cable, the
player will first try to set the color depth to 36
bits, if the 36 bits is not supported by the TV, it
will try to set the color depth to 30 bits, if the 30
bits is not supported by the TV, the player will
set the color depth to 24 bits. If Deep Color is
set to Off, the player will set the color depth to
24 bits.
5 Press to go to the previous menu.
Changing the Audio settings
Selecting the PCM downsampling rate
If your player is connected to an audio receiver or
TV with an optical or coaxial cable, select the
highest PCM sampling rate the amplifier supports.
To select the PCM downsampling rate:
1 Press or to select Settings, then press
ENTER. The Settings menu opens.
2 Press or to select Audio, then press ENTER.
The Audio menu opens.
3 Press or to select PCM Downsampling,
then press ENTER.
4 Press or to select the PCM downsampling
rate you want, then press ENTER. You can select
48KHz, 96KHz, or Off.
Notes
• If your TV has a rectangular (16:9) aspect ratio,
choose one of the 16:9 aspect ratios. If your TV
has a square (4:3) aspect ratio, choose one of the
4:3 aspect ratios.
• Setting your player for one of the 16:9 settings
when connected to a 4:3 TV may produce a
picture that does not correctly fit on the screen.
Note
Your player is capable of sending deep (up to 36-bit)
color over HDMI, if your TV supports it. This expands
the colors displayed from millions to billions, which is
much more vivid than the previous.
NS-WBRDVD2-WBRDVD2-CA_10-0865_MAN_V5.book Page 14 Monday, October 24, 2011 10:28 PM
To Next Page
Loading...
