45
NS-32DR420CA16/ NS-55DR420CA16
www.insigniaproducts.com
Using your Insignia Roku TV
This section provides information on using the day-to-day features of your Insignia Roku TV.
Insignia Roku TV status light
Your Insignia Roku TV has a single status light on the front panel. It goes on and off and blinks in different ways
depending on the status of your Insignia Roku TV, as shown in the following table:
Standby mode energy savings
About 10 minutes after you turn off your Insignia Roku TV, it goes into a very low power standby mode. Until that
happens, if you turn on your Insignia Roku TV again, it immediately displays the activity you selected in the Power on
settings, as described in Power on settings on page 55. After your Insignia Roku TV goes into the low power standby
mode, it takes a bit longer to start up.
Watching broadcast TV channels
To watch broadcast TV, select the Antenna TV tile in the Home screen. Your Insignia Roku TV remembers the last
channel you watched and starts with that channel playing.
Changing channels
To change channels, you can do any of the following:
• Press UP to change to the next higher channel.
• Press DOWN to change to the next lower channel.
• Press LEFT to display the channel list, and then press UP or DOWN to move the highlight through the list one channel
at a time. Or press REWIND and FAST FORWARD to move the highlight through the list one page at a time. When
you’ve highlighted the channel you want to watch, press OK. (If you decide you don't want to change channels, press
RIGHT or BACK).
• Press to switch to the previously tuned channel.
TV condition Status indicator Meaning
On (screen is active) Off
Screen is communicating that your
Insignia Roku TV is on.
Screensaver (screen is active) Off
Screen is communicating that your
Insignia Roku TV is on.
Off (no power) Off Your Insignia Roku TV is not connected
power.
Off (standby) On Your Insignia Roku TV is connected to
power and ready to use.
Starting up from off state
Slow pulsing blink until
startup completes
Your Insignia Roku TV is doing something.
On (receiving update from
USB)
Slow pulsing blink until
update completes
Your Insignia Roku TV is doing something.
Remote control command
received
Dims on/off once
Your Insignia Roku TV has received your
command.
Powering down to standby
mode
Slow pulsing blink until
your Insignia Roku TV
reaches standby.
Your Insignia Roku TV is doing something.
Tip
You also can use the buttons on the TV panel to select Antenna TV, as explained in
Buttons on page 11.
Note
If is not available on your remote control, you can use on the Roku mobile app
or the Jump Back button on a universal remote. For more information, see Other
devices on page 66.
To Next Page
Loading...
