Inspire M1 - Main Base

Foot Plate Main Base
1 - 3” Hex Bolt
2 - 3/8” Small OD Washers
1 - 3/8” Lock Nut
Do Not Over Tighten
2 - 3” Hex Bolts
4 - 3/8” Flat Washers Backing Plate
2 - 3/8” Lock Nuts
Rear Base
STEP 1
NOTE: Use
outside holes in
Ste
p
1.
STEP 2
STEP 1: Attach Rear Base to Main Base using: Two (3” Hex Bolt)
Four (3/8” Flat Washers)
Note: Wrench Tighten Now Two (3/8” Lock Nuts)
Note: Use outside holes in Step 1 One (8 ¼” Backing Plate)
STEP 2: Attach Foot Plate to Main Base using: One (3” Hex Bolt)
Two (3/8” Small OD Washers)
Note: Wrench Tighten Now, but One (3/8” Lock Nut)
do not over tighten.
Foot plate must flip up easily
Page 7