IF1200A Pilot Operating Handbook 19. Disassemble and Store the Aircraft
Locate the Arm Lock for the Arm you are working on (see figure below).
Grasp the Arm Locks on both sides of the joint, and push them in, towards the center
of the aircraft. This loosens the arm. Fold the Arm down.
Follow the previous steps to fold down all four Arms except the two that are directly
above the Landing Gear.
Note: On the left and left-front Arms (see Figure 2 on page 3), install the Propeller
Holders so that the IF logo faces away from the aircraft .
Loosen the clamps that secure the Landing Gear in the aircraft.
Fold the remaining two Arms down, as described in previous steps.
Grasp the Handle in preparation for removing the Landing Gear.
Hold the aircraft by the Handle, remove the Landing Gear, then place the aircraft in
its case.
Figure 21. Arm Release Mechanism
IFT Doc Num 102094, Rev 1.02 Page 43
To Next Page
Loading...
