Insta360 Ace Pro 2 - Waterproofing

Insta360 Ace Pro 2 User Manual
42
Waterproofing
1. Insta360 Insta360 Ace Pro 2 camera is waterproof up to 39ft (12m) without a Dive Case. For
extended underwater use, use the Dive Case. The Dive Case is waterproof to 197ft (60m).
2. Check that the battery compartment is free from dirt or foreign objects. Once the battery is
inserted, close the Battery Cover and ensure the yellow indication mark is completely covered
to ensure waterproofing is not affected.
3. Ensure the USB Port Cover is free from dirt or foreign objects. Ensure it is completely closed
before using the camera underwater.
4. After every use in seawater, soak the camera in fresh water for 15 minutes, gently rinse it with
the flip screen open, and then dry it thoroughly with a soft cloth. Wait until it is completely dry
before using it again.
5. Insta360 Ace Pro 2 comes with a pre-installed Wind Guard. Removing or installing the Wind
Guard and Mic Cap does not affect the camera's waterproofing. Dampness may impact sound
quality and noise reduction. Before using the camera on rainy days or for water sports, remove
the Wind Guard or replace it with the Mic Cap.
To maintain the waterproofing of Insta360 Ace Pro 2:
• Do not use a hair dryer to dry the camera, as it may affect the microphone and speaker and
damage the internal waterproofing ability.
• Avoid operating the camera for extended periods (>1 hour) outside the recommended
temperature range (-4°F to 113°F/-20℃ to 45℃) or in humid environments.
• Do not store the camera in high-temperature or high-humidity environments.
• Do not disassemble the camera.
• Avoid entering water at high speeds. Excessive water impact may damage the device.
• Ensure the camera's Battery Cover, USB Port Cover and Lens Cover are installed and securely
closed, or the camera will not be waterproof.