instanthome.com | 33
Care, cleaning and storage
Anti-block shield
Remove the anti-block shield
Grip the lid like a steering wheel and use
your thumbs to press rmly against the
side of the anti-block shield (pressing
towards the side of the lid and up) until it
pops off the prongs underneath.
Install the anti-block shield
Place the anti-block shield over the prongs
and press down until it snaps into position.
Do not attempt to operate the pressure
cooker without the anti-block shield
installed.
Float valve and silicone cap
Remove the float valve from the lid
Place one nger on the at top of oat
valve, then turn the lid over. Detach the
silicone cap from the bottom side of the
oat valve.
Remove the oat valve from the top of the
lid. Do not discard the oat valve or
silicone cap.
Install the float valve
Drop the narrow end of the oat valve into
the oat valve hole on the top of the lid.
Place one nger on the at top of the oat
valve, then turn the lid over. Firmly attach
the silicone cap to the bottom of the
oat valve.
Do not attempt to operate the pressure
cooker without the oat valve and/or
silicone cap properly installed in the
pressure cooking lid.
Top
Bottom
To Next Page
Loading...
Need help?
General
