17
4. Aer the steamed rice cool down to below 35°C/95°F, mix the cold water and yeast powder
with the rice thoroughly in the container. Make sure that each rice grain is separated, rather
than stuck together. Gently press the rice mixture together and leave a hole in the middle of
the mixture.
5. Add water to the 3rd mark in the inner pot. Lower the container into the inner pot with the
steam rack. Water should submerge about 1cm/0.5in of the boom of the container for even
heat conducon. Make sure to close the lid of the container to avoid excess evaporaon
from the rice.
6. Press the “Yogurt” funcon key and then press the “Adjust” key twice to “Less” mode for Jiu
Niang funcon. The default fermentaon me is 24 hours. You may need to change this
following the instrucon of the yeast.
7. Jiu Niang will be ready when the program nishes. A well-made
fermented glunous rice has transparent liquid and some small
gas bubbles with an aromac smell of liquor and is very sweet.
If there are some white fungi on surface, this is normal. If it has
black fungi, the rice was contaminated during the process and it
should not be consumed. Avoid running the fermentaon for
too long, which causes the rice to turn sour.
8. When the program completes, Instant Pot beeps, displays
“yogt” and goes to standby state.
In order to get a feel for your Instant Pot before jumping in with your favorite recipe, it’s a great
idea to take it for a test run. This will help you to become familiar with your Instant Pot, make sure
that your unit is working perfectly and also clean the unit of possible residues in the process. This
test run can be accomplished in about 15 minutes. It’s oponal but recommended.
1. Make sure the steam release handle and oat valve are unobstructed and clean and that the
sealing ring is properly seated.
2. Insert the inner pot in the cooker base and add water to the “3” mark on the inner pot.
3. Close the lid. Make sure that the steam release handle is poinng to "Sealing" mark on the
lid.
4. Press the "Steam" buon, and press the “-“ buon to change
the me to 2 minutes.
5. In 10 seconds, your Instant Pot will go into the preheang cycle
(display showing “On”). Within a few minutes steam will start
coming out for a minute or two unl the Float Valve pops up
and seals the cooker. Within another minute or two the working
pressure will be reached and the countdown mer will begin.
Once the countdown is nished, your Instant Pot will beep and
automacally go into the “Keep Warm” mode.
That’s it. The test is complete. Press the “Keep-Warm/Cancel” buon
and/or unplug the unit. Once the pot cools down, you can open it
and are ready to try your favorite recipe.
To Next Page
Loading...
Need help?
General
