95
En
You can reset a Remote Mode to its default remote con-
trol code.
You can reset the remote controller to its default settings.
By pressing Remote Mode that’s been programmed with
the remote control code for your component, you can con-
trol your component as below.
For details on entering a remote control code for other
components, see “Entering Remote Control Codes”
(➔ 94).
Controlling a TV
TV is preprogrammed with the remote control code for
controlling a TV that supports the p
*1
(limited to
some models). The TV must be able to receive remote
control commands via p and be connected to the
AV controller via HDMI. If controlling your TV via
p doesn’t work very well, program your TV’s
remote control code into TV and use the TV remote mode
to control your TV.
Controlling a Blu-ray Disc/DVD Player, HD
DVD Player or DVD Recorder
BD/DVD is preprogrammed with the remote control code
for controlling a component that supports the p
*1
(limited to some models). The component must be able to
receive remote control commands via p and be
connected to the AV controller via HDMI.
*1
The p supported by the AV controller is the CEC
system control function of the HDMI standard.
Resetting Remote Mode Buttons
1
While holding down Remote Mode that you want
to reset, press and hold down Home until Remote
Mode button lights (about 3 seconds).
2
Within 30 seconds, press Remote Mode again.
Remote Mode button flashes twice, indicating that
the button has been reset.
Each of Remote Mode is preprogrammed with a
remote control code. When a button is reset, its pre-
programmed code is restored.
Note
•
The learning command is also reset.
Resetting the Remote Controller
1
While holding down Receiver, press and hold
down Home until Receiver lights (about 3 sec-
onds).
2
Within 30 seconds, press Receiver again.
Receiver flashes twice, indicating that the remote
controller has been reset.
Controlling Other Components
To Next Page
Loading...
