Integra DTR-30.2 - Picture Adjustments; Game Mode Setting; Wide Mode Aspect Ratio

53
En
Picture Adjust
Using Picture Adjust, you can adjust the picture quality
and reduce any noise appearing on the screen.
To view the TV picture while setting, press Enter. To
return to the previous screen, press Return.
Note
• If you are using the analog RGB input, the following settings are
not available:
“Film Mode”, “Edge Enhancement”, and
“Noise Reduction”.
■ Game Mode
` Off
:
Game Mode off.
` On:
Game Mode on.
If video signal delay occurs during playback on a video
component (i.e. game console), select the corresponding
input source and set the “Game Mode” setting to “On”.
The delay will decrease but in return the picture quality
will become poor.
■ Wide Mode
*1*2
This setting determines the aspect ratio.
Note
•When the “Game Mode” is set to “On”, this setting is fixed at
“Full”.
` 4:3:
` Full:
` Zoom:
` Wide Zoom:
` Auto
:
According to the input signals and monitor output
setting, the AV receiver automatically selects the
“4:3”, “Full, “Zoom” or “Wide Zoom”. For the
monitor output setting (➔ 44).