To Next PageTo Next Page
Need help?Do you have a question about the Integra DTR-7.3 and is the answer not in the manual?
General| Channels | 7.1 |
|---|---|
| HDMI Outputs | 1 |
| Wi-Fi | No |
| Bluetooth | No |
| Signal-To-Noise Ratio | 106 dB |
| Total Harmonic Distortion | 0.08 % |
| Input Sensitivity | 200 mV |
| Tuner Bands | AM/FM |
| HDMI Switching | Yes |
| HDMI Pass-Through | Yes |
| USB Port | No |
| Phono Input | Yes |
| Audio Formats Supported | Dolby Digital, Dolby Digital EX, Dolby Pro Logic II, Dolby Pro Logic IIx |
| Multi-Room Capability | Yes (Zone 2) |
| THX Certified | Yes (THX Select2) |
| Response Bandwidth | 10 - 100000 Hz |
| Input Impedance | 47 kΩ |
| Surround Sound Effects | Dolby Pro Logic IIx |
| Frequency Response | 10 - 100000 Hz |
| Video Inputs | component video x 3, composite video x 5 |
| Video Outputs | component video x 1, composite video x 2, S-Video x 2 |
| Audio Inputs | digital coaxial x 2, digital optical x 3 |
| Audio Outputs | 7.1 channel audio line-out |
| Weight | 12.8 kg (28.2 lbs) |
Guidelines for safe electrical connection and operation.
Technical specifications related to the unit's amplification capabilities.
Supported audio and video formats and technologies.
Step-by-step guide to insert batteries into the remote control.
Instructions on how to point and operate the remote control.
Identification and description of controls and indicators on the unit's front.
Overview and identification of buttons on the remote control.
Identification and description of rear panel input/output terminals.
Guidance on connecting analog and digital audio sources.
Instructions for connecting composite, S-video, and component video.
Recommendations for optimal speaker placement and types.
Guidelines for positioning speakers for best sound quality.
Instructions for connecting AM loop and FM indoor antennas.
How to connect Zone 2 speakers using specific rear terminals.
Solutions for situations where the remote sensor is obstructed.
How to connect and use Integra/Onkyo components via RI.
Instructions for connecting the main power cord.
Steps to power on the unit from the front panel.
How to select input sources and play media.
Methods for controlling the main volume level.
How to fine-tune bass and treble levels via the Setup Menu.
Instructions for connecting and using headphones.
How to select different sound modes for playback.
Steps to select FM or AM radio stations.
How to store favorite radio stations for quick access.
How to control Zone 2 playback using the unit's front panel.
Procedure for recording the currently active audio/video signal.
Guide to accessing and moving within the unit's setup menus.
Initial settings for speaker impedance and system configuration.
Setting speaker types, sizes, and crossover frequencies.
Entering speaker distances for accurate sound staging.
Configuring digital input jacks and formats for various sources.
Settings for matching audio and video sources.
Adjusting bass and treble levels for sound output.
Adjusting audio timing for synchronization and soundfield effects.
Customizing volume display, muting, and power-on levels.
General introduction to the remote controller's functions.
How to operate connected cassette decks using the remote.
Guide to program remote to control other brand's components.
How to operate satellite tuners using the programmed remote.
Step-by-step instructions for teaching commands to the remote.
How to create and program button sequence macros.
Solutions for no power or power-on issues.
Troubleshooting sound issues related to speakers.
Solutions for radio reception and noise problems.
Common issues with picture and sound synchronization.
Problems related to the remote control's functionality.
Explanations and solutions for specific on-screen error messages.
Capabilities for accessing and enjoying Internet radio.
Steps to access and listen to online radio stations.
How to select and play stored Internet radio stations.
General instructions for using the menu system.
Configuring network settings for Net Audio and Internet Radio.
Manual IP address configuration for network connectivity.
Settings for network wake-up and NTSP port configuration.
Reference for resolving common operational issues.
