78
En
The AV receiver can upconvert component video and
composite video sources for display on a TV connected to
the HDMI OUT. However, if the picture quality of the
source is poor, upconversion may make the picture worse
or disappear altogether.
In this case, try the following:
Important Note Regarding Video Playback
1
If the video source is connected to a component
video input, connect your TV to the COMPO-
NENT VIDEO OUT.
If the video source is connected to a composite video
input, connect your TV to the MONITOR OUT V.
2
On the main menu, select “1. Input/Output
Assign”, and then select “2. HDMI Input”.
Select the relevant input selector, and assign it to
“-----” (➔ 44).
3
On the main menu, select “1. Input/Output
Assign”, and then select “3. Component Video
Input”. (➔ 45):
If the video source is connected to COMPONENT
VIDEO IN 1, select the relevant input selector, and
assign it to
“IN1”.
If the video source is connected to COMPONENT
VIDEO IN 2, select the relevant input selector, and
assign it to
“IN2”.
If the video source is connected to composite video
input, select the relevant input selector, and assign it
to
“-----”.
To Next Page
Loading...
