1
Firmware Update for the DTR-40.2/50.2 & DHC-40.2
The following outlines the methods to update the firmware via network and via USB storage. Please choose
either one that suits your condition. Before you start, carefully read the update procedure. It will take about 30
minutes to update the firmware.
Update via network You need a wired Internet connection to update the firmware. For the update procedure,
please refer to “Updating the Firmware via Network” (pg. 3).
Update via USB storage Please prepare a USB storage device such as a USB flash memory stick. You need
at least 32 MB of available space to update the firmware. For the update procedure, please refer to “Updating
the Firmware via USB” (pg. 6).
Precautions:
Check the network connection before update.
Do not touch
the cable or any other device connected to the AV receiver during updating proc
ess.
Do not access
the AV receiver from PC
during updating process.
Do not shut
down the power of the AV receiver whil
e update.
The storage media in the USB card re
ader may not
work.
If the storage device has been partitioned, each section will be treated as an independent device.
If the USB
mass storage device contains a lot of data, the AV receiver may
take a while to read it.
Operation with all USB
mass storage devices including the ability
to power them is not guaranteed.
Onkyo accepts no responsibility whatsoever for the loss or damage to data stored on a USB mass
storage device when that device is used with the AV receiver. Onkyo recommends that you back up your important
m
usic files beforehand.
If you connect a USB hard disk drive to the USB port, Onkyo recommends that you use its AC adapter to power it.
USB hubs and USB devices with hub functions are not supported. Do not connect your USB mass storage device via
a USB hub.
USB mass storage devices with security functions are not supported.
Limitation of liability
The program and accompanying online documentation are furnished to you for use at your own risk. Onkyo will not be
liable and you will have no remedy for damages for any claim of any kind whatsoever concerning your use of the
program or the accompanying online documentation, regardless of legal theory, and whether arising in tort or contract.
In no event will Onkyo be liable to you or any third party for any special, indirect, incidental, or consequential
damages of any kind, including, but not limited to, compensation, reimbursement or damages on account of the loss of
present or prospective profits, loss of data, or for any other reason whatsoever.
http://www.integrahometheater.com/Products/model.php?
m=DTR-40.2&class=Receiver&source=prodClass
FIRMWARE SITE
To Next Page
Need help?
General
