Integra DTR-40.6 - 7.Hardware Setup

Advanced Settings
46
7.Hardware Setup
Multi Zone
Setting Item Default Value Setting Details
Zone 2 Out Fixed Select which of the integrated amplifier in a
separate room or this unit should be used to
adjust the volume when Zone 2 is active.
"Fixed": Adjust on the Integrated amplifier in a
separate room
"Variable": Adjust on the unit
Zone 2 Maximum
Volume
Off Set the maximum value for Zone 2 to avoid too
high volume. Select a value from "Off", "50" to
"99".
Zone 2 Power On
Volume
Last Set the Zone 2 volume level of when the unit is
turned on. Select a value from "Last" (Volume
level when the unit was turned off), "Min", "1" to
"99" and "Max".
• You cannot set a higher value than that of
"Zone 2 Maximum Volume".
Zone 3 Out Fixed Select which of the integrated amplifier in a
separate room or this unit should be used to
adjust the volume when Zone 3 is active.
"Fixed": Adjust on the Integrated amplifier in a
separate room
"Variable": Adjust on the unit
Zone 3 Maximum
Volume
Off Set the maximum value for Zone 3 to avoid too
high volume. Select a value from "Off", "50" to
"99".
Zone 3 Power On
Volume
Last Set the Zone 3 volume level of when the unit is
turned on. Select a value from "Last" (Volume
level when the unit was turned off), "Min", "1" to
"99" and "Max".
• You cannot set a higher value than that of
"Zone 3 Maximum Volume".
Tuner
Setting Item Default Value Setting Details
AM/FM Frequency
Step
(NorthAmerican
model)
10kHz/200kHz Select a frequency step depending on your
area of residence.
Select "10kHz/200kHz" or "9kHz/50kHz".
• When this setting is changed, all radio
presets are deleted.
AM Frequency Step
(Australian model)
9kHz Select a frequency step depending on your
area of residence.
Select "10kHz" or "9kHz".
• When this setting is changed, all radio
presets are deleted.