121
Controlling Other Components
You can use the AV receiver’s remote controller
(RC-718M) to control your other AV components,
including those made by other manufacturers. This sec-
tion explains how to:
• Enter the remote control code for a component that
you want to control: DVD, TV, VCR, etc.
• Learn commands directly from another component’s
remote controller (see page 130).
• Program the Macro buttons to perform a sequence of
up to eight remote control actions (see page 131).
The following Remote Mode buttons are prepro-
grammed with remote control codes for controlling the
components listed. You do not need to enter a remote
control code to control these components.
For details on controlling these components, see the
pages indicated.
You’ll need to enter a code for each component that you
want to control.
Note:
The remote control codes provided are correct at the time
of printing, but are subject to change.
Preprogrammed Remote Control
Codes
Integra/Onkyo DVD player (page 124)
Integra/Onkyo CD player (page 127)
Onkyo cassette recorder with u (page 129)
Onkyo RI Dock with u (page 128)
Entering Remote Control Codes
Remote
Mode
Receiver
Display
Number
buttons
1
Look up the appropriate remote
control code in the separate
Remote Control Codes list.
The codes are organized by category
(e.g., DVD player, TV, etc.).
2
(3 seconds)
While holding down the Remote
Mode button to which you want
to enter a code, press and hold
down the [Display] button (about
3 seconds).
The Remote Mode button lights up.
Notes:
• Remote control codes cannot be
entered for the [Receiver] and
[Zone 2] buttons.
• Only TV remote control codes can be
entered for the [TV] button.
• Apart from the [Receiver], [TV], and
[Zone 2] buttons, remote control
codes from any category can be
entered for the Remote Mode but-
tons. However, these buttons also
work as input selector buttons
(page 53), so choose a Remote Mode
button that corresponds with the
input to which you connect your
component. For example, if you con-
nect your CD player to the CD input,
choose the [CD] button when enter-
ing its remote control code.
3
Within 30 seconds, use the num-
ber buttons to enter the 5-digit
remote control code.
The Remote Mode button flashes
twice.
If the remote control code is not entered
successfully, the Remote Mode button
will flash once slowly.
To Next Page
Loading...
Need help?
General
