Intel 1037U

40
CPU C1E Report
The optional settings are: [Disabled]; [Enabled].
Use this item to enable or disable CPU C1E report to OS.
CPU C3 Report
The optional settings are: [Disabled]; [Enabled].
Use this item to enable or disable CPU C3 (ACPI C2) report to OS.
CPU C6 Report
The optional settings are: [Disabled]; [Enabled].
Use this item to enable or disable CPU C6 (ACPI C3) report to OS.
CPU C7 Report
The optional settings are: [Disabled]; [Enabled].
Use this item to enable or disable CPU C7 (ACPI C3) report to OS.
 Memory Configuration
Press [Enter] to make settings for the following sub-items:
DIMM profile
Use this item to select DIMM timing profile that should be used.
The optional settings are: [Default DIMM profile]; [Custom Profile].
When set as [Custom Profile], the sub-item ‘Custom Profile Control’ will appear
for user to manually set memory timing configuration:
Memory Frequency Limiter
Use this item to set maximum memory frequency selection in Mhz.
The optional settings are:[1067]; [1333] [1600].
tCL
The setting range for ‘Cas Latency’ is from [4] to [18].
tRCD
The setting range for ‘Row to Col Delay’ is from [1] to [38].
tRP
The setting range for ‘Ras Precharge’ is from [1] to [38].
tRAS
The setting range for ‘Ras Active Time’ is from [1] to [586].
tWR
The setting range for ‘Write Recovery Time’ is from [1] to [38].
tRFC
The setting range for ‘Refresh Recovery Delay Time’ is from [1] to [9363].