Intel Desktop Board D815EEA Product Guide
38
Setting the BIOS Configuration Jumper
CAUTION
Always turn off the power and unplug the power cord from the computer before changing the
jumper. Moving the jumper with the power on may result in unreliable computer operation.
OM10107
1
3
J7B1
Figure 19. BIOS Configuration Jumper Block Location
This three-pin jumper block, shown in Figure 19, enables all desktop board configurations to be
done in BIOS Setup. Table 7 shows the jumper settings for the Setup program modes.
Table 7. Jumper Settings for the BIOS Setup Program Modes
Function/Mode Jumper Setting Configuration
Normal
1-2
1
3
The BIOS uses current configuration information and passwords
for booting.
Configure
2-3
1
3
After the POST runs, Setup runs automatically. The maintenance
menu is displayed.
Recovery
None
1
3
The BIOS attempts to recover the BIOS configuration. A
recovery diskette is required.
To Next Page
Loading...
Need help?
General
