Windows 3.x/MS-DOS Installation 4-29
5 Continue with the installation until it is completed.
6 Following the UB instructions, modify your CONFIG.SYS file by
adding the following lines:
For DOS:
DEVICE = [
PATH
]M16BNDIS.EXE
where [path] is the drive and directory in which you installed your
network operating system.
7 Use a text editor to modify your PROTOCOL.INI file as follows:
For each protocol that you want to bind, set the protocol
definition area of the PROTOCOL.INI file to:
BINDINGS = UBLOOP
At the end of the file, add the following fragments:
[UBLOOP]
DRIVERNAME = UBLOOP$
BINDINGS = INTELNET
;INTEL ADAPTER
[INTELNET]
DRIVERNAME = INTEL$
8 Reboot the PC.
Wollongong PathWay Access for DOS
NDIS and ODI Drivers
Wollongong PathWay Access for DOS can be installed using Intel NDIS
or ODI drivers. Installation instructions for both types of driver are
provided below. For information on which driver is appropriate for your
network environment, refer to the Wollongong PathWay Access for DOS
documentation.
Wollongong PathWay NDIS Installation
1 Run the Installation Program from Intel Disk 1, Installation Disk.
2 Choose Wollongong PathWay Access from the Select Network
Operating System screen.
To Next Page
Loading...
Need help?
General
