Windows NT Installation 3-3
Windows NT 4.0 Installation
Installing the PRO/100 PC Card under Windows NT 4.0 requires
installing the network driver and the modem separately. The network
driver must be installed first.
PCMCIA Services Verification
Before installing the Intel adapter, make sure that PCMCIA services are
enabled on your computer.
1 Select Devices from the Control Panel.
2 Scroll down the Device list to the PCMCIA device. The Status
should be Started and the Startup should be Boot. If this is not how
PCMCIA is configured, then click Startup and set the Startup Type
to Boot and click OK.
Network Driver Installation
Use the following procedure to install the network driver:
3 Shutdown the computer and turn off the power.
4 Insert the PRO/100 PC Card into the PC Card slot in the com-
puter.
5 Power-up the computer.
6 Select Network from the Control Panel.
To Next Page
Loading...
