Intel Express 10 User Manual

44
CHAPTER 3 Intel Express 10/100 Fast Ethernet Switch
set-ip
set-ip <IPaddress>
Sets the IP address of the switch (technically, the switch’s SNMP
agent). If no IP address was previously set (default configuration), the
new value is saved in NVRAM and used immediately. Otherwise, the
new value is stored in NVRAM, but you must use the
warm-reset
command or cycle the power for changes to take effect.
set-ip 192.001.001.064
Device IP Address unchanged for this session
Device IP Address change in the NVRAM OK
The device NVRAM IP address will be:
IP address : 192.001.001.064
set-ip-conf
set-ip-conf <IPaddress> <netmask> <broadcast>
Sets the IP address, netmask (subnet mask), and broadcast IP address.
If no IP configuration was previously set (default configuration), the
new values are saved in NVRAM and used immediately. Otherwise,
the new values are stored in NVRAM, but you must use the
warm-reset command or cycle the power for changes to take effect.
SYS_console> set-ip-conf 192.1.1.64 255.255.255.0 192.1.1.255
Device IP Address set for this session
Device IP Address change in the NVRAM OK
The device IP configuration in the next session will be:
IP address : 192.001.001.064
IP netmask : 255.255.255.000
IP broadcast : 192.001.001.255
get-bootp
Displays the current state of the BOOTP process. By default, BOOTP
is disabled.
set-bootp
set-bootp {enable|disable}
Enables or disables BOOTP. With BOOTP enabled, the switch looks
for a BOOTP server at startup if no IP configuration is defined.
get-slip
Displays the current SLIP address. By default, no SLIP address is
assigned.

Intel Express 10 Specifications

General

Brand	Intel
Model	Express 10
Category	Network Router
Language	English