5
9 To install an additional adapter, press the Esc key to go back to the Step 7
prompt “Select an adapter to install.” Then, repeat steps 7-9 for each
additional adapter you want to install.
10 To complete the driver installation process, go back to the Installation
Options screen by pressing the Esc key until you see it.
11 Choose Exit to return to the console prompt.
NOTE
: If the adapter cannot transmit or receive following the installation, you
may need to modify the frame type in the AUTOEXEC.NCF file.
Novell NetWare 4.1x Only
Use the NetWare install program to install the PRO/100+ adapter driver in
Novell NetWare 4.1x. For Novell NetWare 3.11 and 3.12, see the readme files.
For DOS ODI, see the section DOS and Windows 3.1 Setup for Novell NetWare
DOS ODI Clients. The following procedure is a condensed description of the
installation process.
NOTE
: Prior to installing, either load DOS or NetWare drivers for your
computer’s CD-ROM drive or create a floppy disk from the CD on a
different computer.
1 From the NetWare console, type LOAD INSTALL and press Enter.
2 From the Installation Options screen, choose “Driver options” and press
Enter.
3 Choose “Configure network drivers” and press Enter. If any drivers are
already loaded, a list of them appears.
4 Choose “Select an additional driver” and press Enter. A list of drivers
appears.
5 Insert the Intel floppy disk or CD and choose “Install an unlisted driver” by
clicking Insert.
6 Specify the correct path to your media if necessary by pressing F3. Press
Enter to search the floppy or CD-ROM drive.
7 The driver name is displayed: Intel(R) PRO/100+ Adapter. Press Enter to
select it.
8 The next screens ask for frame and protocol types. Use the arrow keys to
select specific items or choose the defaults. Select “Save parameters and
load driver” to continue.
9 To install an additional adapter, press the Esc key to go back to the Step 7
prompt “Select an adapter to install.” Then, repeat steps 7-9 for each
additional adapter you want to install.
10 To complete the driver installation process, go back to the Installation
Options screen by pressing the Esc key until you see it.
11 Choose Exit to return to the console prompt.
NOTE
: If the adapter cannot transmit or receive following the installation, you
may need to modify the frame type in the AUTOEXEC.NCF file.
P100se~2.fm Page 5 Tuesday, January 5, 1999 10:03 AM
To Next Page
Loading...
